OWENS CROSS ROADS, Ala. (Sept. 4, 2024) — Gun enthusiasts and hunters often wonder, “How difficult is it to replace a factory rifle stock?” At AG Composites, we understand this is a common question among those new to tearing apart a bolt-action rifle. In response, we have compiled a comprehensive guide to help you understand the process and why you might want to consider replacing your factory stock.
Factory rifle stocks are typically made of either plastic (polymer) or wood. While plastic stocks are lightweight, they lack the rigidity needed for consistent shot-to-shot accuracy. Wood stocks, on the other hand, although more rigid, are heavier and prone to swelling and shrinking with changes in temperature and humidity. This can lead to moisture retention and rust development on the barrel and receiver components.
Moreover, factory rifle stocks often lack the ergonomic features that shooters desire. Some even make contact with the barrel, compromising accuracy. If you have decided that you want to upgrade to a custom aftermarket stock, the process of swapping them out is surprisingly straightforward, regardless of whether you choose a fiberglass or carbon fiber AG Composites stock. The results, however, are astonishing.
To replace your factory rifle stock with an AG Composites premium stock, follow these simple steps:
1) Ensure that the gun is unloaded completely, prioritizing safety above all else.
2) Remove the bolt from the receiver to allow for easier disassembly.
3) Take out the front and rear action screws. Note that on a Remington 700, the longer screw goes behind the trigger, while the shorter screw goes on the muzzle side.
4) If your rifle has a hinged floorplate (BDL) or no floorplate at all (ADL), remove the magazine spring and follower, setting them aside for later use. If you plan to use bottom metal with a detachable box magazine (DBM), you will not need the factory spring and follower. AG Composites offers both BDL and DBM bottom metal options with an M5 footprint.
5) Carefully remove the barreled action from the factory stock.
6) Place the barreled action into your new AG Composites stock, ensuring that the recoil lug aligns with the stock’s recoil lug inlet. The action should fit snugly into the new stock.
7) Verify that the action is properly seated in the stock’s inlet by checking if the tang of the action rests against the stock and that the barrel is straight in the receiver. Make any necessary adjustments to the action’s placement.
8) Install the action screws using the longer screw in the rear hole of the bottom metal. If you have purchased AG Composites bottom metal, new action screws will be provided.
9) Torque both action screws to 65 inch-pounds, ensuring a secure fit.
10) If your new bottom metal is BDL, open the hinged floorplate and install the factory spring and follower.
With the floorplate closed and the bolt back in action, congratulations! You have successfully completed the installation of your new AG Composites rifle stock. It’s that simple!
Ready to enhance your shooting experience? Order your AG Composites rifle stock today and enjoy improved accuracy and ergonomics. Refrain from settling for factory stocks that limit your potential. Upgrade to AG Composites and take your shooting to the next level!
About AG Composites
AG Composites is a veteran-owned that designs and manufactures advanced composite products in Owens Cross Roads, Ala. The company uses modern design software to create Computer-Aided Design (CAD) models and the highest quality carbon fiber epoxy, fiberglass and paint to make its line of rifle stocks. Every stock is tested with the action, bottom metal, and barrel hardware before it ships to the customer. The company is known for delivering its products in weeks rather than months. AG Composites’ mission is to be the most responsive, reliable, and supportive supplier in the advanced composites industry. The company is a Made-In-The-USA advanced composites company based near Huntsville, AL. The company can be reached at 1-833-AGSTOCK , This email address is being protected from spambots. You need JavaScript enabled to view it. or www.agcomposites.com
Read the full article here
